Hilti SID 2-A Mode D'emploi page 14

j) The user and any other persons in the vicinity must wear suitable
eye protection, a hard hat, ear protection, protective gloves and
breathing protection while the tool is in use.
4.2.2 Careful use of the power tool
a) Secure the workpiece. Use clamps or a vice to secure the work-
en
piece. The workpiece is thus held more securely than by hand and both
hands remain free to operate the power tool.
b) Check that the insert tools used are compatible with the chuck
system and that they are secured in the chuck correctly.
c) Ensure fastener and attachment will withstand the level of torque
generated by the tool.
damage the fastener/attachment and possibly lead to personal injury.
4.2.3 Careful use of the cordless tool
a) Ensure the switch is in the off position before inserting battery pack.
Inserting the battery pack into power tools that have the switch on invites
accidents.
b) Do not expose batteries to high temperatures and keep them away
from fire. This presents a risk of explosion.
c) Do not disassemble, squash or incinerate batteries and do not
subject them to temperatures over 80°C. This presents a risk of fire,
explosion or injury through contact with caustic substances.
d) Avoid ingress of moisture. Moisture in the interior of the tool may cause
a short circuit and chemical reactions resulting in burns to the skin or fire.
e) Observe the special guidelines applicable to the transport, storage
and use of Li-ion batteries.
f) Observe national and international transport regulations when shipping
batteries (transportation by road, rail, sea or air).
g) Remove the battery before storing or transporting the tool.
h) Avoid short circuiting the battery terminals. Before inserting the
battery in the tool, make sure that the battery terminals and the
terminals in the tool are free from foreign objects. Short circuiting the
battery terminals presents a risk of fire, explosion and chemical burns.
Do not charge or continue to use damaged batteries (e.g. batteries
i)
with cracks, broken parts, bent or pushed-in and/or pulled-out
contacts).
j) If the battery is too hot to touch it may be defective. Place the tool in
a location where it can be kept under observation, well away from
flammable materials, and allow it to cool down. Contact Hilti Service
after the battery has cooled down.
10
Printed: 12.11.2014 | Doc-Nr: PUB / 5206129 / 000 / 00
All manuals and user guides at all-guides.com
Excessive torque may overstress, strip or