Loading / Removing The Cutting Inserts In The Holder For The Cutting Insert; Loading / Removing The Holder For The Cutting Insert - DS Produkte FP7714 Mode D'emploi

Loading / removing the cutting inserts in the holder for the cutting insert

Loading / removing the holder for the cutting insert

All manuals and user guides at all-guides.com
1. Turn the locking mechanism on the back of the holder for
the cutting insert until the opening for the cutting inserts is
exposed.
2. Select a suitable cutting insert pair (also see chapter
"Product contents and device overview", section "Cutting
inserts").
3. Slide the desired cutting inserts into the opening. In the
process, make sure that the respective cutting insert is
correctly inserted on the front side and is not left to hang.
4. Turn the locking mechanism on the back of the holder for
the cutting insert until the opening for the cutting inserts is
blocked and thus fi xed in place.
5. Open the locking mechanism on the back of the holder for
the cutting insert to remove the cutting inserts and pull out
the cutting inserts.
1. Place the holder for the cutting insert in the motor unit.
Make sure that the holder for the cutting insert is properly
positioned on the drive shaft.
2. Place the fastener for locking the holder for the cutting in-
sert on the fi ll chute. Turn the fastener towards the LOCK
arrow to tighten it.
3. To remove the holder for the cutting insert, turn the rotat-
ing fastener towards the OPEN arrow in order to open the
fastener.
4. Take the holder for the cutting insert off of the drive shaft.
20