Safety Rules - Hilti DD 100 Mode D'emploi

ORIGINAL OPERATING INSTRUCTIONS
Contents

Safety rules

DD100 basic unit
Versions with additional equipment
Assembly instructions/conversion
Drilling speeds
Water collector
Safety regulations
DD100 motor/technical data
Overload indicator
Aids for starting drilling
Accessories
Ground fault interruptor PRCD
Maintenance
Manufacturer's warranty – tools
Disposal
EC declaration of conformity
16
Printed: 07.07.2013 | Doc-Nr: PUB / 5069508 / 000 / 00
All manuals and user guides at all-guides.com
Safety rules
1. General safety rules
-WARNING- Read all instructions!
Failure to follow all instructions listed
16
below may result in electric shock, fire
19
and/or serious injury. The term "power
20
tool" in all of the warnings listed below
21 refers to your mains operated (corded)
power tool or battery operated (cord-
22
less) power tool.
22+23
24
SAVE THESE INSTRUCTIONS
25
26
1.1 Work area
27
a) Keep the work area clean and well
lit. Cluttered and dark areas invite
27
accidents.
28
b) Do not operate power tools in explo-
28
sive atmospheres, such as in the
28
presence of flammable liquids,
29
gases or dust. Power tools create
29
sparks which may ignite the dust or
fumes.
c) Keep children and bystanders away
while operating a power tool.
Distractions can cause you to lose
control.
1.2 Electrical safety
a) Power tool plugs must match the out-
let. Never modify the plug in any way.
Do not use any adapter plugs with
earthed (grounded) power tools.
Unmodified plugs and matching out-
lets will reduce risk of electric shock.
b) Avoid body contact with earthed or
grounded surfaces such as pipes,
radiators, ranges and refrigerators.
There is an increased risk of electric
shock if your body is earthed or
grounded.
c) Do not expose power tools to rain or
wet conditions. Water entering a
power tool will increase the risk of
electric shock.
d) Do not abuse the cord. Never use the
cord for carrying, pulling or unplug-
ging the power tool. Keep cord away
from heat, oil, sharp edges or moving
parts. Damaged or entangled cords
increase the risk of electric shock.
e) When operating a power tool out-
doors, use an extension cord
approved for outdoor use. Use of a
cord suitable for outdoor use reduces
the risk of electric shock.
1.3 Personal safety
a) Stay alert, watch what you are
doing and use common sense when
operating a power tool. Do not use
a power tool while you are tired or
under the influence of drugs, alco-
hol or medication. A moment of
inattention while operating power
tools may result in serious personal
injury.
b) Use safety equipment. Always wear
eye protection. Safety equipment
such as dust mask, non-skid safety
shoes, hard hat, or hearing protection
used for appropriate conditions will
reduce personal injuries.
c) Avoid accidental starting. Ensure the
switch is in the off position before
plugging in. Carrying power tools
with your finger on the switch or
plugging in power tools that have the
switch on invites accidents.
d) Remove any adjusting key or wrench
before turning the power tool on. A