Description; Te 70-D/Avr And Te 70/Avr; Te 70-D/Avr Y Te 70/Avr; Te 70-D/Avr E Te 70/Avr - Hilti TE 70-D/AVR Mode D'emploi

Obligation signs
Wear eye Wear a hard
en
protection hat
Wear
breathing
protection
Symbols
Read the Return waste
operating material for
instructions recycling.
before use
Alternating Hertz
current

2 Description

2.1 Use of the product as directed
The power tool is an electrically-powered rotary hammer (TE 70-D/AVR) or combihammer with pneumatic hammering
mechanism. The ATC (Active Torque Control) function incorporated in the TE 70‑ATC/AVR and TE 80‑ATC/AVR
provides greater operating comfort while drilling
The power tool is designed for drilling in concrete, masonry, metal and wood and can also be used for chiseling (not
the TE 70-D/AVR).
The power tool may be used to work only on non-flammable materials.
Under certain conditions, the power tool is suitable for use for mixing (see "Tools, accessories" and "Operation").
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Nationally applicable industrial safety regulations must be observed.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be used only in a dry environment.
Do not use the power tool where there is a risk of fire or explosion.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
Modification of the power tool or tampering with its parts is not permissible.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
2
All manuals and user guides at all-guides.com
Wear ear Wear
protection protective
gloves
Volts Amps
Rated speed Revolutions
under no per minute
load
Revolutions Diameter
per minute
Chiseling Chisel
position
adjustment
Location of identification data on the power tool
The type designation and serial number can be found
on the type identification plate on the machine or tool.
Make a note of this data in your operating instructions
and always refer to it when making an enquiry to your
Hilti representative or service department.
Type:
Generation: 03
Serial no.:
Double Hammer
insulated drilling