Cleaning And Maintaining The Lcd Monitor - Waeco MOBITRONIC M170L Instructions De Montage Et De Service

_M170L.book Seite 37 Mittwoch, 20. August 2008 12:08 12
M170L
➤ Press the "MENU" button (4) four times to set the mirror image function.
The setting should be selected so that, for example, an obstacle to the right of the back
of the vehicle also appears on the right of the monitor.
➤ Press the "–" button (2), to switch on the mirror image function.
➤ Press the "+" button (4), to switch off the mirror image function.
➤ Press the "MENU" button (3) until the red "Exit" function is highlighted.
➤ Press the "MENU" button (3) to exit.
Note
I
You can reset the monitor to the factory settings for brightness, contrast, tint and
volume.
To do this, proceed as follows:
➤ Press the "MENU" button (3) five times.
➤ Press the "–" button (2), to reset the device to the factory settings.
➤ Press the "MENU" button (3) until the red "Exit" function is highlighted.
➤ Press the "MENU" button (3) to exit.
9

Cleaning and maintaining the LCD monitor

Caution!
e
Remove the cable before cleaning the monitor to prevent short circuiting.
Caution
a
Do not use sharp or hard objects or cleaning agents for cleaning as these may
damage the device.
➤ Occasionally clean the device with a damp cloth.
10 Guarantee
The statutory warranty period applies. If the product is defective, please contact the man-
ufacturer's branch in your country (see the back of the instruction manual for the address-
es) or your retailer.
For repair and guarantee processing, please include the following documents when you
send in the device:
A copy of the receipt with purchasing date
A reason for the claim or description of the fault
Cleaning and maintaining the LCD monitor
37