Télécharger Imprimer la page

Starting The Engine; Driving - Jacobsen Fairway 305 Manuel De L'opérateur Et De Sécurité

Publicité

Les langues disponibles

Les langues disponibles

7
OPERATION
GB
9.
Slow down and use extra care on hillsides. Read Section 3.7. Use caution when operating near drop
off points.
10.
Never use your hands to clean cutting units. Use a brush to remove grass clippings from blades.
Blades are extremely sharp and can cause serious injuries
OPERATION OF THE
MACHINE
Read the Safety Instructions.
BEFORE OPERATING FOR THE FIRST TIME
Check and adjust tyre pressure, if
necessary, to 1 kg/cm
Add diesel fuel to tank if neccesary.
Check engine oil and top-up, if necessary.
Check radiator coolant and top-up, if
necessary (50% antifreeze solution).
Make sure you understand the information
contained in the previous sections.
7.4

STARTING THE ENGINE

The following procedure is for starting cold engines.
1.
Ensure the FWD/REV pedal is in the
neutral position, the mow switch is off, the
throttle setting is in a mid position and the
parking brake is applied.
2.
Turn the ignition switch to position No.2
and hold until the glow plug light goes off
(5-10 sec.)
3.
Turn ignition key fully clockwise to the
start position and operate the starter motor
until the engine starts (This should only
take a few seconds)
4.
When the engine starts, release the key
immediately and it will return to the RUN
position.
5.
If the engine does not start, preheat the
glow plugs and try again.
GB-20
All manuals and user guides at all-guides.com
WARNING
DO NOT USE ON SLOPES GREATER THAN 15°
2
(14 psi).
JACOBSEN FAIRWAY 305 Series CG
SAFETY AND OPERATORS MANUAL
NOTES:
Warm engine - When the engine is warm
because of surrounding temperature or
recent operation, step No.2 of the cold
engine starting procedure may be skipped
(no need to preheat glow plugs).
If the engine fails to start after two tries
(with preheat if necessary), wait 20
seconds and try again.
The starter motor should never be run
continuously for longer than 30 seconds
or it may fail.
7.5

DRIVING

Release brake - Make sure the parking
brake is released before attempting to go
forward or reverse.
Forward - Gently depress the top plate of
the FWD/REV foot pedal to reach desired
ground speed.
Reverse - Gently depress the bottom
plate of the FWD/REV foot pedal to reach
desired ground speed.
To stop - Gently return the FWD/REV foot
pedal to the neutral position.
NOTES:
Use complete foot to operate both forward
and reverse.
Do not move pedal suddenly–always
operate slowly and smoothly. Never move
pedal violently from forward to reverse or
vice versa.
Always keep foot firmly on the foot pedal–
a too relaxed foot control may result in a
jerky motion.

Publicité

Chapitres

loading