6
CONTROLS
GB
6.1
STARTER KEY SWITCH
The starter key (A) should be turned clockwise to
the 'pre-heat' (No. 2) position to heat the glowplugs
when the green warning lamp goes out, on warning
lamp disply module, turn the starter key clockwise
to the 'start' (No. 3) position to start the engine. After
starting, the key should be released and allowed to
return automatically to the 'on' (No. 1) position for
normal running.
6.2
THROTTLE CONTROL LEVER
The lever (B) should be moved away from the
operator to increase the engine speed and towards
the operator to decrease the engine speed.
NOTE: Engine should be used at full speed.
6.3
STEERING WHEEL RAKE ADJUSTMENT
The steering wheel is adjustable for rake. The
clamping release knob (A) is situated on the side of
the control console on the left hand side. To adjust
turn the clamping knob anticlockwise to release and
pivot the steering wheel backwards and forwards to
obtain desired setting then lock in position by
turning clamping knob clockwise.
6.4
TRACTION FOOT PEDAL
To move the machine forward press the front of the
foot pedal (A). To reverse depress the rear of the foot
pedal. When the pedal is released it will return to its
neutral position.
6.5
NEUTRAL LATCH (B)
Has two functions:
1.
The engine cannot be started when the
Neutral Latch is depressed.
2.
The FWD/REV pedal will not work as
described if the Neutral Latch is not
simultaneously depressed.
All manuals and user guides at all-guides.com
JACOBSEN FAIRWAY 305 Series CG
SAFETY AND OPERATORS MANUAL
GB-11