Stihl AR 900 Notice D'emploi page 42

English
Troubleshooting
Always disconnect the battery from the power tool before performing any maintenance work.
Condition
Power tool does not start after switch-on
40
All manuals and user guides at all-guides.com
Cause
No electrical contact between power
tool and battery
Battery has low charge
(1 LED on battery flashes green and
four long beeps sound)
Battery too hot / too cold
(1 LED on battery glows red)
Malfunction in battery
(4 LEDs on battery flash red and a
rapid succession of beeps sound for
several seconds)
Power tool too hot
(3 LEDs on battery glow red)
Electromagnetic problem or malfunc-
tion in machine
(3 LEDs on battery flash red)
Moisture in power tool and/or battery
Remedy
Remove adapter, check contacts and refit
adapter
Charge the battery
Allow battery to cool down / allow battery to
warm up slowly at temperature of about
15°C - 20°C
Disconnect battery from power tool, take it
off your back, observe battery and contact
your STIHL servicing dealer immediately.
If the battery emits fumes, heats up, smells,
makes noises or shows signs of deforma-
tion, disconnect it from the power tool, take
it off your back, put it down and immediately
move a safe distance away. Keep children
and animals away from the work area. Keep
battery away from combustible materials.
Allow power tool to cool down
Take the adapter out of the power tool and
refit it. Switch on the power tool – if the light
emitting diodes still flash, the power tool has
a malfunction and must be checked by a
STIHL servicing dealer.
Allow power tool / battery to dry
AR 900