ANSMANN POWERLINE 4 SMART Mode D'emploi page 12

ted, automatic start of repair mode if required to
regenerate deep-discharged rechargeable batte-
ries and gentle pre-charging with reduced current
ƒ ƒ
Automatic charge start after rechargeable battery
is inserted
ƒ ƒ Microcontroller-monitored charge control
ƒ ƒ
Multiple over-charging protection through voltage
monitoring (-dU) and safety timer
ƒ ƒ
Fully-charged detection and automatic changeover
to pulse maintenance charging
ƒ ƒ Individual slot monitoring (separate charging for
each rechargeable battery)
ƒ ƒ Reverse polarity protection
ƒ ƒ
Defective battery detection
ƒ ƒ
Indication of the rechargeable battery status via a
multicolour LED for each charge slot
ƒ ƒ Worldwide use (100V-240V AC / 50-60Hz)
USE
Fit the mains plug (different mains plugs may be inclu-
ded, e.g. Euro, UK, US or AU, depending on the design and
the specific country variant) onto the two mains contacts
and slide it on until it reaches the stop in the guide (see
illustration). Ensure that the plug latches into place
audibly when sliding on. The charger is now ready for use.
Deutsch |
Español | Por tuguês | Italiano
English | Français | Pусский