Bosch MSGP3L Manuel D'utilisation page 16

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 20
en Overview of illumination modes
modes
illumination
of
Overview
Overview of illumination
modes
modes
illumination
of
You can find an overview of the different il-
Overview
lumination modes here.
Illumination
Status
mode
The LEDs light
The device is in the
up pink.
sprouting phase or holi-
day mode is switched
on.
The LEDs light
One or more height
up white.
modules are inserted.
The device is in stand-
ard mode.
The LEDs flash
¡ Manual switch
twice.
¡ The maximum capa-
The LEDs light
Descaling has started
up green.
and the pump is run-
ning.
The LEDs light
→ "Troubleshooting",
up or flash red.
Page 18
The LEDs do
¡ The device is in the
not light up.
¡ → "Troubleshooting",
solution
nutrient
of
Quantity
Quantity of nutrient solution
solution
nutrient
of
You can find an overview for the status of
Quantity
the nutrient solution here.
Illumination
Status
mode
The LEDs flash
The maximum capacity
white twice.
of the water bowl has
been reached.
16
All manuals and user guides at all-guides.com
between sleep mode
and standard mode
is confirmed.
city of the water bowl
has been reached.
The LEDs flash white
twice.
sleep mode.
Page 18
Illumination
Status
mode
The LEDs light
Only a little nutrient
up blue for
solution remains in the
5 seconds
water bowl.
while the pump
is running.
The LEDs flash
The water bowl contains
blue 10 times
too little nutrient solu-
every
tion. Nutrient solution
3 minutes. The
should be topped up.
pump has
switched off.
information
General
General information
information
General
Do not install the device under the following
conditions:
¡ in direct sunlight
¡ close to air-conditioning systems and
heaters
¡ outdoors
¡ in areas at risk from frost
¡ in areas with an ambient temperature ex-
ceeding 36 °C
¡ on vibrating surfaces, e.g. on washing
machines
¡ on magnetic metal surfaces
device
the
Preparing
Preparing the device
device
the
→ Fig.
Preparing
 - 
2
3
Notes
¡ Clean all parts before using for the first
time.
¡ Put the cleaned and dried parts out
ready for use.
device
the
Installing
Installing the device
device
the
→ Fig.
Installing
 - 
4
5
solution
nutrient
Mixing
Mixing nutrient solution
solution
nutrient
Mixing
Add 1 measuring spoon (2ºg) of nutri-
ents to 1ºlitre of fresh tap water.
→ Fig.
6
Notes
¡ On initial start-up add 1 measuring
spoon (2 g) of nutrients to 1.5 litres of
fresh tap water.
Printed on 100% recycled paper

Publicité

Table des Matières
loading

Table des Matières