Stadler Form MAX Mode D'emploi page 8

Recommendation: Turn the thermostat control (2) clockwise as far as
the stop. If the desired room temperature has been reached, turn the
thermostat control (2) anticlockwise until the appliance switches off.
If the room temperature drops, then Max switches on again automati-
cally. Please note that after the thermostat switches off automatically, it
takes a few minutes for the heater to switch on again!
5. Frost-protection circuit
prevent the room temperature from falling below approx. +5°C, set the
rotary control (1) to position I or II (depending on the size of room, Position
II for larger rooms) and the room-temperature control (2) to
ance switches on automatically at approx. +5°C and off again at approx.
+7°C. In this way, frost damages can be avoided.
6. Protection against over-heating: Max is fitted with an over-temperature
safety device which switches off the appliance in the case of a technical
fault or improper use. Should this occur, pull the mains cable (6) out of
the supply socket and remedy the fault or correct the method of use. The
appliance can be put back into use when it has cooled down and has been
disconnected from the mains supply for a short time.
Note: Make sure that there is always sufficient space between the
appliance and the wall or other large objects (> 50 cm). The air flow
must not be blocked by objects of any kind.
Cleaning
Before servicing the heater and after each occasion of use, switch off the
appliance and unplug the mains cable from the socket.
• Attention: Never immerse the appliance in water (danger of short-circuit).
• To clean the appliance, only wipe it down with a damp cloth and then dry
it carefully.
• Take care that the air intake and outflow grilles do not become exces-
sively dusty; clean them occasionally with a dry brush or vacuum cleaner.
Repairs
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician. If improper repairs are carried out, the warranty
lapses and all liability is refused.
• Never operate the appliance if the adaptor or plug is damaged, after it has
malfunctioned, if it has been dropped or has been damaged in any other
way (cracks/breaks in the casing).
• Do not push any object into the appliance.
• If the appliance is beyond repair, make it unusable immediately by cutting
through the cable and hand it in at the collection point provided for the
purpose.
Disposal
The European directive 2012 / 19 / CE on Waste Electrical and Electronic
Equipment (WEEE), requires that old household electrical appliances must
not be disposed in the normal unsorted municipal waste stream. Old appli-
ances must be collected separately in order to optimize the recovery and
recycling of the materials they contain and reduce the impact on human
*
: Set the room-thermostat control (2) to
*
. To
*
. The appli-