Stadler Form MAX Mode D'emploi page 7

• The appliance is only to be used in the home for the purposes described
in these instructions. Unauthorised use and technical modifications to the
appliance can lead to danger to life and health.
• Never submerge the unit in water (danger of short circuiting).
• Never run a defective unit (e.g. supply cord).
• Never touch energized parts.
• Only connect the cable to alternating current. Observe the voltage infor-
mation given on the appliance. Do not use extension cords.
• The heater must not be located directly below a socket-outlet.
• Do not open the appliance (repairs only by service agents).
• Do not use this heater in the immediate surroundings of a bath, a shower
or a swimming pool (the appliance is not splash-proof).
• Do not run the power cord over sharp edges and make sure that it does
not get trapped. Do not pull the plug from the socket with wet hands or by
holding on to the power cord.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• Please make sure that the used socket remains accessible.
• Do not run the heater on an uneven or soft surface.
• CAUTION: In order to avoid a hazard due to inadvertent resetting of the
thermal cut-out, this appliance must not be supplied through an external
switching device, such as a timer.
• WARNING: In order to avoid overheating, do not cover the air inlet or air
outlet - fire hazard!
• Do not use the heater in small rooms (below 4 m
environment, or for drying laundry.
• Do not touch the front grille, it might reach hot temperature.
• Use the heater only under supervision.
• Do not insert any object and/or finger into the openings of the heater.
• To extinguish burning appliances only use fire blankets.
• Unplug the appliance before filling and cleaning.
Setting up / operation
1. Having set up the Max heater in the desired position, insert the mains
cable (7) into the mains socket (6) on the appliance and connect the cable
(7) to the household supply socket.
2. Switch on the Max to the desired level by means of the rotary control (1).
3. Rotary control (1):
Position 0
Position
Position I
Position II
4. Room thermostat (2): The room-thermostat control (2) allows for a vari-
able temperature adjustment.
Setting: for maximum temperature, turn the control clockwise,
for minimum temperature, turn the control anti-clockwise.
= Off
= Ventilation, turn the room-thermo-
stat rotary control (2) clockwise as
far as the stop
= Heating, 800 W
= Heating, 2000 W
in size), in explosive
2