Witter MR64U Notice De Montage

MATERIALS:
A 1 Crossbar
X 6 M12 x 100 x 1.75 Bolts, Nyloc Nuts, Small Flat Washers & Large Flat Washers (30od / 40od)
ZN 1 Chosen Neck
ZE 1 Electric Plate
FITTING:
1. Remove rear lights. Remove the bumper, disconnecting any wiring that may be attached.
2. Remove the towing bracket on the right hand side & hand back to the customer.
3. Where fitted, remove the bumper beam & hand it back to the customer. Refit the bumper beam fixings
back into the rear panel.
4. Cut the bumper using the diagram below as a guide.
5. Loosely attach Cross Bar (A) to each chassis using fixings (X). Note: Large washers fit to the outer face
of the chassis, using the 30od washers at the position highlighted below.
6. Replace the bumper, affixing any wiring removed earlier. Replace the rear lights.
7. Affix the chosen neck (detachable shown for illustration purposes only). Tighten all Bolts to their
recommended torque setting.
Note: This towbar must be used with either a Witter Towball (part number Z1X) or Class A50-1 or A50-X towball
dimensionally conforming to A50-1 with a 'D' and 'S' value greater than or equal to that of the towbar.
Please refer to the vehicle specification for the trailer weight and nose limits, which must be observed.
Recommended torque settings: M12 - 95 Nm
Fitting
Instructions
µW0001MR64-FIT$011508110000tÄ
W0001MR64-FIT$011508110000
TOWBAR
For Mercedes Vito / V Class
(2014 -)
MR64U