BLAZE BLZ-GRIDDLE-LTE-LP Guide D'utilisation Et D'entretien page 32

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Fuel (Gas) Conversion Instructions for BLAZE Gas Griddles
CAUTION: This should only by performed by a licensed gas professional.
Main Burners:
Remove the griddle plate to expose the main burners in the appliance. There is a single screw holding
1.
the griddle plate to the housing located below the rear exhaust/flue cover in the middle of the griddle
plate.
On the bottom rear of each burner is a cotter pin. Remove cotter pin.
2.
installation into an outdoor kitchen)
To remove burner, pull rod upwards and slide burner toward the rear of the appliance. Repeat for each
3.
burner.
Where the burner was previously located, connecting to the main valve through the hole in the basin should now be
4.
empty space.
Inside the space you will find the end of the valve (toward the front of appliance), with an orifice (brass fitting),
5.
screwed into the end of the valve stem.
Carefully remove the orifice with a 6mm socket set and extension. (These are extremely fragile! When
6.
unscrewing, be extremely gentle, for you could easily break the brass fitting and have to replace the valve).
Once the old orifice is removed, replace it with the new orifice, (repeat for all burners). When re-installing the
7.
orifice, do not over tighten or you will strip the brass fitting. Very little pressure is needed!!!
Inspect burners for proper flame appearance. The ideal flame appearance is one that is mostly blue and not lifting
8.
off of the burner surface. There is an air shutter found at the end of the burner (close to the valve) which can be
either opened or closed to make adjustments to the flame's appearance. To adjust, remove the burner from the
appliance and loosen the Philips head screw holding the air shutter to the burner. If the flame is yellow, open the air
shutter to make the flame bluer. If the flame is lifting off of the burner surface, slightly close the air shutter. Re-tighten
the Philips head screw and re-install the burner to recheck the flame appearance. Repeat if necessary.
Blaze Outdoor Products Instructional Book
Page | 33
(unless they were removed prior to

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Blz-griddle-lte-ng

Table des Matières