BLAZE BLZ-GRIDDLE-LTE-LP Guide D'utilisation Et D'entretien page 29

Flue Cover Assembly
The Flue Cover Assembly is located at the back of the griddle plate assembly. Wipe the flue cover clean with a
cloth. You may also remove it for cleaning with a hot soapy solution. Make sure the flue cover is fully inserted
back into the BLAZE GRIDDLE again. Ensure this area remains un-obstructed at all times.
Stainless Steel Burners
The appliance must be completely cooled before proceeding. Make sure the gas supply is off and all control knobs are
in the "OFF" position. You must remove the griddle plate to expose the main burners in the appliance. There is a single screw
holding the griddle plate to the housing located below the rear exhaust/flue cover in the middle of the griddle plate. Once
removed, use two people to lift the griddle plate up and out of the way. On the bottom rear of each burner is a cotter pin.
Remove cotter pin. To remove burner, pull upwards and slide burner toward the rear of the appliance. Repeat for each
burner. To clean the burners, use a wire brush to clean the exterior of the burner. Free all clogged ports of obstructions with
a small metal object. Clean out any debris through the air shutter and inspect the burner inlet to ensure it is free of any
obstructions. Use a rod or pipe cleaner to remove any debris within the burner if necessary.
Spider and Insect Warning
Spiders and other insects can nest in the burners and orifices of this and any other outdoor products, which causes the gas to
flow from the front of the burner and have a "Flash Back". This can create a dangerous condition that can cause a fire behind
the control panel, damaging the BLAZE GRIDDLE and making it unsafe to operate. Inspect the burners and orifices once a year,
or if the BLAZE GRIDDLE has not been used for more than a month or if any of the following conditions occur:
1. The smell of gas and with the burner flames appearing yellow.
2. The griddle does not reach temperature.
3. The griddle heats unevenly.
4. The burner makes popping noise.
NOTE: Make sure each burner is properly placed after cleaning. It is very important to ensure the end of the burner is
installed appropriately onto the gas valve to ensure gas flows safely into the burner. Failure to meet these conditions can
be dangerous causing personal injury and/or property damage.
Blaze Outdoor Products Instructional Book
Page | 29