Unpacking Unit - BLAZE BLZ-GRIDDLE-LTE-LP Guide D'utilisation Et D'entretien

UNPACKING UNIT:

Product Inspection:
A final inspection of your product occurs at the factory to ensure a quality product is packaged. Please
re-check for possible shipping damage immediately after unpacking your griddle. If the appliance is found to have some
damage, contact your dealer immediately as often the shipping carrier will have a timeframe to report damage. Please also
save the packaging material the product came with as that is at times inspected by the shipping carrier.
Caution: Do not leave the unit under the sun with the protective film on for a long period of time as it will make the film difficult
to remove and/or leave markings on the materials which are not covered by the warranty.
Never place your fingers inside the observation openings in the griddle plate during removal or
replacement of the griddle plate as they could be pinched. Never place your fingers inside the
observation openings in the griddle at any time as injury could occur.
Your Blaze Series Appliance comes pre-assembled and requires very little setup. We do however; recommend the use of
professional help during the installation of your unit as improper installation may affect your warranty. Remove the unit
from the box along with all accessories and check that no damage has occurred to the unit or any parts. Remove all
packaging materials, labels and protective plastic film before you start cooking.
Burners: Check the burner tubes and remove any obstructions that may be in the ports or holes. Using cold water and a
brush will be sufficient. Make sure all foreign particles are removed from the burner before use. Make sure the air shutter
on the burners is slightly opened (to about 1/8" for NG and 1/4" for LP). When finished ensure that the burners are aligned
with the valve orifice and seated in the bracket slot. This is accomplished by first placing the burner tube shutter hole
securely over the valve orifice and ensuring the male post on the griddle chassis rests in the corresponding slot in the rear
NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.
Blaze Outdoor Products Instructional Book
Page | 15