Cleaning Your Appliance - BLAZE BLZ-GRIDDLE-LTE-LP Guide D'utilisation Et D'entretien

Caution: Always allow the BLAZE GRIDDLE to cool before cleaning. Never place your fingers inside
the observation openings in the griddle plate during removal or replacement of the griddle plate as
they could be pinched. Never place your fingers inside the observation openings in the griddle at any
time as injury could occur.
NOTE: You should clean your appliance after each use to maintain the overall appearance over the life of your appliance. After
the first use, it is normal for your appliance to become discolored in certain areas from the heat produced by the burners.
Exterior Cleaning
When cleaning your appliance, always scrub and polish in the direction of the stainless steel grain. Wipe down the exterior of
the appliance to remove any splatter or grease. Do not use harsh abrasives. Use a stainless steel cleaner to clean the
exterior surface for a polished look. To remove baked-on foods, use a fine to medium grit non-metallic abrasive pad with a
stainless steel cleaner to avoid specks of grease collecting in the grain causing the appearance of rust.
Griddle Plate Cleaning
After every use and when cool, you can thoroughly wipe the plate with the grain using a rough cloth to remove food
·
particles and other cooking residue.
You may use a mixed solution of water and vinegar (2 tablespoons of vinegar per half gallon) and a scotch brite pad
·
(working in the same direction as the stainless steel grain) to remove the cooked-in food. Special griddle cleaners may also
be commercially available in your area which may be used to remove heavy soil build-up.
Thoroughly rinse the griddle with room temperature water after using any of these cleaners.
·
Caution: Never flood a hot griddle with cold water! This causes griddle warping and can cause the griddle plate to crack.
Dry the griddle plate and coat it lightly with the cooking oil of choice or apply a non-stick cooking spray. This will
·
prevent the griddle from getting surface rust.
Drip Tray
Clean the drip tray after each use. Failure to do so could result in a fire. Once the appliance has cooled
completely, remove the tray by pulling it all the way out until it comes free. Clean the tray with hot soapy water and re-install.
If using an oven cleaning agent, be sure to carefully follow the manufacturer's instructions to avoid damage to the
stainless steel. Make sure the drip tray is fully inserted back into the Griddle.

Cleaning Your Appliance

Blaze Outdoor Products Instructional Book
Page | 28