Activation/Deactivation Of The Multi-Tab Function - AEG FAVORIT 55010 VI Notice D'utilisation

74
These products are detergents with a combined cleaning, rinsing and salt functions. They
can also contain other different agents depending on which kind of tablets you choose ("3
in 1", "4 in 1", "5 in 1" etc...).
Check whether these detergents are suitable for your water hardness. See the manufac-
turers instructions.
This function can be selected with all washing programmes. With the selection of this
function the inflow of rinse aid and salt from each respective supply container is auto-
matically deactivated.
Select the "Multi-Tab function " before the start of a washing programme.
Once this function is selected (indicator light illuminated) it will remain active also for the
following washing programmes.
With the use of the "Multi-Tab function", the cycle durations may change.
Once the programme is running, the "Multi-Tab function " can NO longer be changed. If
you want to exclude the "Multi-Tab function " you have to cancel the programme setting
and then deactivate the "Multi-Tab function ".
In this case you have to set a washing programme (and desired options) again.

Activation/deactivation of the Multi-Tab function

Simultaneously press and hold the two Multi-Tab buttons (D and E), until the "Multi-Tab
function" indicator light illuminates. This means that the function is active.
To deactivate the function press the same buttons again until the "Multi-Tab function"
indicator light turns off.
If the drying results are not satisfactory we suggest that you:
1. Fill up the rinse aid dispenser with rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position 2.
• The activation/deactivation of the rinse aid dispenser can only be possible with the
"Multi-Tab function" active.
Activation/deactivation of the rinse aid dispenser
1. Press the On/Off button. The dishwasher must be in setting mode.
2. Press simultaneously buttons B and C, until the lights of buttons A , B, and C start
flashing.
3. Press button B, the lights of buttons A and C turn off while the light of button B goes
on flashing: the end of programme indicator light illuminates, indicating that the rinse
aid dispenser has been activated.
4. To change the setting, press button B again until the end of programme indicator light
turns off.
5. To memorise the operation, switch off the dishwasher by pressing the On/Off button.
If you decide to turn back to the use of standard detergent system we advise that you:
1. Deactivate the "Multi-Tab function".
2. Fill up the salt container and the rinse aid dispenser again.
3. Adjust the water hardness setting to the highest setting and perform 1 normal washing
programme without loading any dishes.
4. Adjust the water hardness setting according to the hardness of the water in your area.
5. Adjust the rinse aid dosage.