Error
A solid
RED LED
for each bank is lit
A blinking
RED LED with
solid 25% YELLOW LED
A blinking
RED LED with
solid 50% YELLOW LED
A blinking
RED LED with
solid 75% YELLOW LED
A blinking
RED LED with
solid 25%, 50% and 75%
YELLOW LEDs
A blinking GREEN and
25% YELLOW LEDs
Model
Part No.
System Volts
MK 106PCL
1831061
MK 212PCL
1832121
MK 318PCL
1833181
12 / 24 / 36
MK 110PCL
1831101
MK 220PCL
1832201
MK 330PCL
1833301
12 / 24 / 36
MK 440PCL
1834401
12 / 24 / 36 / 48
MK 550PCL
1835500
12 / 24 / 36 / 48 / 60
©2021 Johnson Outdoors Marine Electronics, Inc.
TROUBLESHOOTING
•
No battery is connected to an output cord. This may also indicate a blown fuse in the fuse holder.
•
The battery is connected reverse polarity.
•
A short circuit.
•
The battery voltage is below 0.5 volts. The bank will not charge a battery in this condition. If in
Lithium Mode, the charger will attempt to wake the battery from Standby Mode.
•
The battery voltage is above 16 volts. The bank will not charge a battery in this condition.
•
The battery did not rise above 10.5V within a specific time limit or the battery did not complete
the Bulk Mode stage withing a specific time limit. The battery may be damaged and will not
continue to be charged.
•
There is a damaged temperature sensor. The bank will not operate if this occurs.
•
The charger overheated. Unplug the charger and allow it to cool before resuming the
charging process.
•
The charger is set to Lithium Mode and the charger exceeded the number of attempts allowed to
wake the battery from Standby Mode.
•
The battery is less than 10.5 volts and the charger is in low power output safety mode. Full
charging will begin once the battery reaches 10.5 volts. If the battery voltage does not rise above
10.5 volts, then make sure all loads are disconnected from the battery and try again.
Specifications Input Voltage: 95-135VAC, 60Hz
Output
Banks
per Bank
(amps)
12
1
6
12 / 24
2
6
3
6
12
1
10
12 / 24
2
10
3
10
4
10
5
10
ERROR CONDITIONS
Solution
Total
Input
Output
Output
Cable
Cable
(amps)
6
18AWG - 6'
16AWG - 6'
12
18AWG - 6'
16AWG - 6'
18
18AWG - 6'
16AWG - 6'
10
18AWG - 6'
16AWG - 6'
20
18AWG - 6'
16AWG - 6'
30
18AWG - 6'
16AWG - 6'
40
16AWG - 6'
16AWG - 6'
50
16AWG - 6'
16AWG - 6'
Size
Weight
D x H x W
(lbs)
(inches)
9-7/8 x 3-1/2 x 4
4
9-7/8 x 3-1/2 x 5-7/8
6.4
9-7/8 x 3-1/2 x 7-3/4
8.4
9-7/8 x 3-1/2 x 4
4
9-7/8 x 3-1/2 x 5-7/8
6.4
9-7/8 x 3-1/2 x 7-3/4
8.4
9-7/8 x 3-1/2 x 9-7/8
10.5
9-7/8 x 3-1/2 x 11-3/4
12.5
minnkotamotors.com | 21
Input Current
(120VAC,
60Hz)
2A
4A
6A
2.8A
5.6A
8.4A
11.2A
13A