Fuse Replacement; Cleaning - MC Crypt X-1000 Notice D'emploi

10. Maintenance
a) Fuse Replacement
If the fuse must be replaced, observe that only fuses of the indicated type and rated current (see Technical Data)
must be used.
Never repair fuses or bridge the fuse holder.
• After the device is successfully disconnected from the mains (pull mains plug and disconnect mains line at the de-
vice!), carefully lift out the fuse holder with the defective fuse at the mains connection POWER with a suitable screw
driver.
• Remove the defective fuse and replace it with a fuse of the same type.
• Now carefully plug the fuse holder with the new fuse back into its holder at the mains connection POWER.
• After this, you can reconnect the device to the mains and take it into operation.
b) Cleaning
Disconnect the device from the power supply and leave it to cool down before cleaning.
The device is maintenance-free and you should therefore never open it. If you open it, the guarantee will expire.
Only clean it with a soft, dry cloth or a brush only. Never use aggressive cleaning agents or chemical solutions as the
surface of the casing could be damaged.
The fog machine can be cleaned with a moist cloth on the outside. Never use aggressive cleaning agents, chemical
solutions or scouring agents as the paint coating could be damaged.
Avoid deposits and residue in the fog fluid channels by using a special fog machine cleaner, which you will also find
in the Conrad range. Observe the instructions for cleaning liquid.
All manuals and user guides at all-guides.com
27