Set-Up - MC Crypt X-1000 Notice D'emploi

All manuals and user guides at all-guides.com

7. Set-Up

Installation of the device must be carried out by a specialist familiar with the hazards and the relevant
regulations. Maintenance, operation and commissioning of this device must only be carried out by
qualified persons.
When choosing a location for your device, make sure to avoid impact, vibration, dust, hot and cold
temperatures and dampness. Furthermore, no powerful transformers or motors must be used close
to the device.
When setting up the device, make sure that the power cord and the remote control cable are not
crushed and cannot be damaged by any sharp edges.
Never operate the device on flammable surfaces or close to flammable objects. Always keep a
distance of at least 0.5 m to flammable objects.
Observe that the fog exit opening is not pointed at persons, animals or open flame. The escaping
hot steam may cause burns (comply with a safety distance of 0.5 m).
Ensure a sufficient ventilation of the device, maintain a free zone of 0.2 m around the device and
never cover the ventilation openings.
Never place the device on an unstable underground. Ensure that it does not fall down and cause
injury.
The operating position of the device is horizontal so that the tank cannot spill when filling and in
operation.
The device must be set up out of normal reach. If the fog machine is operated in an elevated location,
make sure no one can enter the space beneath it (danger of slipping and injury through hot fog
liquid and its residues).
During installation or service work, the area below the place of setup must be cordoned off.
The setup area must be designed in such a way that it can support the tenfold rated load for at least
one hour without being deformed permanently.
All statutory regulations applicable in the respective country must be observed when setting up
the device.
Acceptance test (in case of industrial/public use):
Before first use and after any significant modifications, the installation (including the electrical connections)
must be inspected by an official expert.
A yearly inspection by an expert is required.
At least every 4 years, an acceptance test must be carried out by an expert.
• Set up the fog machine under observation of the above safety notes.
• Loosen the two knurled screws at the fog outlet and align the fog exit as desired.
• Tighten the two knurled screws again.
21