Operation; General Information - MC Crypt X-1000 Notice D'emploi

All manuals and user guides at all-guides.com

9. Operation

a) General Information
Always pull the mains plug before filling the fog machine.
Never fill the fog machine with flammable liquids or add such to the fog liquid. Only ever use suitable
water-based fog liquids (the Conrad range features suitable fog liquids).
Never tilt the fog machine. Fog liquid may leak out or enter the inside of the device and cause
damage there or injure the operator.
Make sure that no liquid enters the inside of the device when you are filling it with fog liquid. This
may cause damage to the device and potentially fatal electrical shock.
Ensure that the tank never runs empty during fog operation. Should this happen nevertheless, turn the fog
machine off immediately using the mains switch and let it cool down.
Refill the tank after cooling.
If no fog emerges, the device is still warming up or reheating.
Slight fog lag after deactivation/disconnection of a device is normal and does not suggest a defect.
If you no longer require the device, disconnect the mains plug and let the device cool down.
Then empty the tank if the device is not used for any extended period. This prevents leaking of fog liquid
during transport or storage.
• Ensure that the mains plug is not plugged in.
• Unscrew the tank cover from the device and fill fog liquid into the tank. The liquid level must be between the LOW
and FULL marks at all times in operation.
• Then screw on the tank closure lid again.
• Plug the mains plug into a mains socket with a protective ground contact.
• Switch on the device with the mains switch. With the device on, the mains switch lights up and the fog machine heats
up.
• Heating up takes approx. 2 minutes. During heating up, the display indicates UP.
• Once the device has reached its operating temperature and is ready for operation, the green indicator LED on the
remote control is lit and the display at the fog machine shows reAd.
24