Kuppersbusch FKF8800.0i Mode D'emploi page 30

30
Problem
The compressor does not
start immediately after
pressing the "Shopping", or
after changing the tempera‐
ture.
Water flows inside the refrig‐
erator.
Temperature cannot be set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The "Shopping function" is
switched on.
This is normal, no error
has occurred.
Food products prevent the
water to flow into the wa‐
ter collector.
The "Shopping function" is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
The "Shopping function" is
switched on.
There is no cold air circu‐
lation in the appliance.
Solution
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "Closing the door".
Refer to "Shopping function".
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Switch off "Shopping function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "Shopping function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Add less food products at the
same time.
Open the door only if necessa‐
ry.
Refer to "Shopping function".
Make sure that there is cold
air circulation in the appliance.