Ammann AVP 2220 Mode D'emploi page 48

5. Maintenance
5.7.8 Hydraulic hose lines
B8299325.cdr
1 Ammann Article No.
2 Manufacturer/Month and year of manufacture
3 Max. operating pressure
The function of hydraulic hose lines must be tested at regular in-
tervals (minimum once a year) by an expert (with a knowledge of
hydraulics).
Hose lines must immediately be replaced in the following in-
stances:
–
Damage to the outer layer to the inner lining (abrasion marks,
cracks, cuts, etc.).
–
Brittleness of the outer layer (cracking of hose covering).
–
Unnatural deformations of the hose line. This applies to both a
pressureless and pressurised condition (e.g. layer separation,
blister formation, crushed areas, kinks).
–
Leaks.
–
Damage or deformation of hose fittings (impaired sealing
function).
–
Hose slips out of the fitting.
–
Corrosion of fitting (degrading of function and strength).
–
Improper installation.
–
Use beyond the expiry date of max. 6 years.
1
2
3
43