Functional Description - Makita JS1300 Manuel D'instruction

WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
volts
amperes
hertz
alternating current
no load speed
Class II Construction
revolutions or reciprocation per minute

FUNCTIONAL DESCRIPTION

CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
Switch action
1
004668
CAUTION:
Before plugging in the tool, always check to see
•
that the switch trigger actuates properly and returns
to the "OFF" position when released.
Switch can be locked in "ON" position for ease of
•
operator comfort during extended use. Apply
caution when locking tool in "ON" position and
maintain firm grasp on tool.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
For continuous operation, pull the switch trigger and then
push in the lock button.
To stop the tool from the locked position, pull the switch
All manuals and user guides at all-guides.com
USD201-2
1. Switch trigger
2. Lock button
2
trigger fully, then release it.
Hook
The hook is convenient for temporary hanging the tool.
When using the hook, pull it out in ''A'' direction and then
push it in ''B'' direction to secure in place.
A
1
004676
004677
When not using the hook, return it back to its initial
position by following the above procedures in reverse.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the tool.
Replacement of blades
CAUTION:
Never remove the blades with bare hands. Wear
•
gloves. Otherwise it can cause injury.
Removing cutting head
1
2
3
004688
Use the hex wrench to loosen the three screws which
secure the cutting head. Pull the cutting head straight out
to remove it with turning it left and right alternately.
4
1. Hook
B
1. Cutting head
2. Screws
3. Loosen
4. Hex wrench
4