Spypoint FL-A Manuel De L'utilisateur page 14

26
DISTANCE
The distance dial sets the motion detector sensitivity. Use this
feature to set the detection range required. Turn dial to the
right to increase distance. Range of detector is between 5 and
50ft. The best method to determine a proper distance is to turn
"MODE" switch to "Set/Test" and to walk perpendicularly to
the front of the camera where action is anticipated. When the
detector is activated, the test light on the front of the camera
will blink once. At this moment, the camera operator may want
to adjust the distance setting, and/or change the direction or
height of the camera.
ChANGE OF ThE LIGhTING MODULE
It is necessary to turn the camera OFF, to remove the batteries
and to wait 2 minutes before replacing the visible lighting flash
module by the IR-35 infrared module. Simply raise the module
with the fingers by the spaces designed for this purpose in order
to remove it. Then, slowly reintegrate the replacement module
by taking care not to damage the metal connectors at the back
of the module.
Visible flash module
All manuals and user guides at all-guides.com
IR-35 IR infrared module
DOWNLOAD TO A COMPUTEr
To transfer or view photos and videos on a PC, you must first
turn the camera off and use the USB cable (supplied) to connect
the camera to your computer. The computer will then recognize
the camera as a removable disk drive. Camera operator must
wait until the termination of computer software installation
(few seconds) before clicking on Desktop. Then, click on
removable disk and look to find folder with DCIM. Click on
the DCIM folder and all the photos and videos will be found in
100DSCIM folder. Photos and videos can be viewed, edited or
deleted with your computer's software.
Taking the SD card out of the camera and inserting it in the
computer port will achieve same results. If no SD slot is built
into the computer, a multi-card reader RD25-1 (sold separately)
must be used.
27