Assembling The Stand Mixer - KitchenAid 5KSM7580X Mode D'emploi

ASSEMBLING THE STAND MIXER

Attaching the bowl and beaters
Turn speed control to "0" (OFF), and
1
unplug Stand Mixer.
Spring Latch
Fit bowl supports over locating pins;
3
press down on back of the bowl until
bowl pin snaps into the spring latch. If
not securely snapped into place, bowl
will be unstable and wobble during use.
Pouring Chute
If using the pouring shield*, from the
5
front of the Stand Mixer, slide the
pouring shield over the bowl until it
is centered. The bottom rim of the
pouring shield should fit within the bowl.
NOTE: Rotate the pouring shield* so the
motor head covers the U-shaped gap in
the shield. The pouring chute will be just
to the right of the attachment hub as you
face the Stand Mixer.
* Pouring shield included only for models 5KPM5, 5KSM7580X and 5KSM7591X
10 | ASSEMBLING THE STAND MIXER
W11356007A.indb 10
Locating Pin
Place bowl lift lever into down position.
2
Slip a beater (flat, wire whip, or dough
4
hook) onto the beater shaft and press
upward as far as possible. Turn beater to
the right, hooking it over the pin on the
beater shaft.
Raise the bowl into mixing position
6
by rotating the bowl lift lever
counterclockwise to the straight up
position. The bowl must always be
in the raised position when mixing.
AS
3/18/2019 2:02:00 PM