Candy CSE V9DF-S Manuel D'utilisation page 60

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

DELAY START button
l
This button allows to delay the start of the
programme from 30 minutes (1 hour on
some models) to 24 hours in 30 minutes
intervals (1 hour on some models).The
delay selected is shown on the display.
l
After pressing the START/PAUSE button
the time showed decrease minute after
minute.
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start again to resume the counting.
TIME CYCLE SELECTION button
l
It's possible transform a cycle from
automatic to programmed, up to 3
minutes after the start of the cycle.
l
The progressive pressure increases the
time in 10 minute intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off the
dryer.
l
In case of incompatibility, all indicator
lights flash quickly for 3 times.
DRYING SELECTION button
l
This button allows to set the desired
dryness level editable option up to 3
minutes after the starting of the cycle:
Ready to Iron: it leaves the garments
slightly wet to facilitate ironing.
Dry Hanger: to get garment ready to
be hang.
Dry wardrobe: for laundry that can be
directly stored.
Extra-dry: to get completely dry
garments, ideal for full load.
l
This appliances is equipped with Drying
Manager function. On automatic cycles,
each level of intermediate drying, prior to
the
reaching
indicated by flashing the light indicator
corresponding to the degree of drying
reached.
In case of incompatibility, all indicator
lights flash quickly for 3 times.
RAPIDS button
l
It's possible to switch an automatic
program to rapid program, up to 3
minutes after the start of the cycle. The
progressive pressure increases the time
(30-45-59 minutes).
l
After this selection to reset the automatic
drying functioning it is necessary to
switch off the dryer.
In case of incompatibility, all indicator
lights flash quickly for 3 times.
ANTI CREASE button
l
During the cycle the option sets alternate
movements of the drum to reduce the
folds and automatically sets the drying
level to "Ready to Iron". Moreover this
option activate an anti-creases movement
of the drum pre cycle in case of activation
of the delay and at the end of drying
cycle. It is activated every 10 minutes, up
to 6 hours after the end of the drying
cycle.
l
To
stop
the
programme selector to OFF. Useful when
it's not possible to remove immediately
the laundry.
60
the
selected
one,
movements
set
is
the

Publicité

Table des Matières
loading

Table des Matières