Candy CSE V9DF-S Manuel D'utilisation page 54

2. VENTILATION
Installation of the exhaust hose
l
It is essential to use a venting hose to
carry the hot moist air away from the
dryer unless the dryer is situated in an
open space with a good air flow around it.
l
Recirculation of the moist air will prevent
the efficient operation of the dryer.
l
The hose is assembled to the machine as
shown.
l
The hose may be fitted through a wall or
through an open door or window. The
hose is 110 mm in diameter and will
extend 1,8 meters.
The following guidelines should be followed
when installing the exhaust hose.
l
Do not use two hoses joined together as
the drying performance will be reduced.
l
Do not restrict the flow of air through the
hose e.g. by kinking it or fitting a smaller
diameter connector to mount to a wall
opening.
l
Avoid the hose making U shaped curves
as this will restrict the flow of air and
increase the chance that water will collect
in the hose.
l
Check the hose regularly to remove any
build-up of fluff or water that may have
collected in it.
The following diagrams give examples of
good and bad installations.
WARNING
The installation should prevent air
flowing back into the machine through
the exhaust hose. The machine could
be damaged electrically, and its safety
compromised, if the exhaust hose air
is allowed to re-enter the tumble dryer.
54
H max
20 inches
(50.80 cm)