Kubota GZD15-3 LD Instructions De Montage page 14

10
BTightening the Bolts
Tighten up the M14 x 30 bolts (2) (4 pcs. for each side) to
the frame.
Tightening torque: 123.6 to 147.0 N-m (12.6 to 15.0 kgf-
m)
(1) PIPE, ROPS UNDER
(2) Bolt (M14 x 30)
BInstalling the ROPS Pipe
Use M10 flange bolts and flange nuts to install PIPE
(ROPS) to PIPE, ROPS UNDER as shown in the figure
below.
Tightening torque: 48.1 to 55.9 N-m (4.9 to 5.7 kgf-m)
(1) PIPE, ROPS
(2) Flange bolt (M10)
(3) Flange nut (M10)
All manuals and user guides at all-guides.com
(A) PIPE, ROPS UNDER
BGZD15-3 HD & GZD21-2 HD Hose Clamp
Positions
(1) Upper lift arm
(2) Clamp on the bag base
(3) Clamp on the lift cylinder
(4) Clamp below the fender's
top level
(5) Clamp above the check wire
stay level
(6) Clamp on the upper lift arm
A Lift the back base to its top limit and clamp it tightly.
A Make sure the hoses are parallel, not crossing each
other.
A Make sure that the hoses are clamped on the upper lift
arm.
A Move up and down the back base to make sure that
the hoses do not stretch tight (P), nor come into
contact with the lift base and rear tires (Q).
A Be sure to pass the clamp through the Under ROPS
pipe stay and to clamp the hoses. (R)
A Be sure to clamp the sleeve ends of the hoses. (S)
A Be sure to clamp the white-taped zone of the hoses
above the cylinders. (T)
A Be sure to clamp the hoses below the top of the
fenders. (U)
(A) Pass close to the headed
pin
(B) 200 mm (reference)
(C) 300 mm (reference)
(D) 200 mm (reference)