SICK CoreTech DRS60 Notice D'instruction page 9

CoreTech Encoder
Encoders with face mount flange
In this flange design, there are 2 installation
options:
• via the threaded holes on the flange
side or
• by clamping the mounting spigot
Subject to change without notice
Installation via the threaded holes on the
flange side (Figure 3)
Lock the drive shaft on the application side.
Mount the coupling (1); take care that it does
not touch the encoder flange.
Push the encoder, with mounted coupling (1)
onto drive shaft and centring recess (6).
Fix the encoder with 3 M4 screws (5), fix the
coupling (1) to the drive shaft.
The coupling must not be subjected to any
axial stresses.
Make the electrical connections with the
voltage switched off. Switch on the voltage
and check the functioning of the encoder.
Installation via the mounting spigot
(Figure 4)
(Please note!)
Since the mounting spigot is also the means
of centring, the clamping device must be
constructed in such a way that when it is
clamped firmly, no impermissible angular or
shaft offset results.
Lock the drive shaft on the application side.
Mount the coupling (1); take care that it
does not touch the encoder flange. Fit the
encoder, with mounted coupling (1), onto the
drive shaft, and the mounting spigot into the
clamping device (7).
Clamp the encoder firmly with the screw (8).
Fix the coupling (1) on the drive shaft.
The coupling must not be subjected to any
axial stresses.
Make the electrical connections with the
voltage switched off. Switch on the voltage
and check the functioning of the encoder.
8013425/1EF3/2021-12-13
GB