SICK CoreTech DRS60 Notice D'instruction page 7

CoreTech Encoder
CoreTech encoders are measuring instru-
ments produced in accordance with
recognised industrial regulations.
• The installation of the encoder is to be
carried out by trained personnel with
knowledge of electrical engineering
and precision engineering.
• A CoreTech encoder must be used
only for the purpose appropriate to its
design.
Subject to change without notice
!
Safety advice
Observe the professional safety and accident
prevention regulations applicable to your
country.
Switch off the voltage to all the devices/
machines and plant involved in the mounting.
Never electrically connect or disconnect the
encoder with the voltage switched on,
otherwise this may lead to damage to the
encoder.
For the satisfactory operation of the devices,
care must be paid to good earthing and to a
screen connection suitable for EMC (screen
connected at both ends).
Avoid striking the shaft or the collet.
GB
8013425/1EF3/2021-12-13