SICK CoreTech DRS60 Notice D'instruction page 10

CoreTech Encoder
Encoders with stator coupling for blind
hollow shaft (Figure 5)
Lock the drive shaft on the application side.
Loosen the socket-head screw (1) on the
clamping ring (2).
Push the encoder and collet onto the drive
shaft. Take note of installation Figure (6).
Fix the torque support (3) with 4 M3 screws
(4) and washers.
Firmly tighten the socket-head screw (1) on
the clamping ring (2).
Tightening torque 1.3 Nm
Make the electrical connections with the
voltage switched off. Switch on the voltage
and check the functioning of the encoder.
Subject to change without notice
Encoders with stator coupling for through
hollow shaft (Figure 7)
Lock the drive shaft on the application side.
Loosen the socket-head screw (1) on the
clamping ring (2).
Push the encoder and collet onto the drive
shaft. Take note of installation Figure (8).
Fix the torque support (3) with 4 M3 screws
(4) and washers.
Firmly tighten the socket-head screw (1) on
the clamping ring (2).
Make the electrical connections with the
voltage switched off. Switch on the voltage
and check the functioning of the encoder.
GB
8013425/1EF3/2021-12-13