Topcom Butler 2405 Mode D'emploi page 21

Masquer les pouces Voir aussi pour Butler 2405:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Butler 2405/2410
Butler 2405/2410
• 'SEARCHING' and the symbol
• The RFPI code (each base unit has a unique RFPI code) appears on the display and a signal
sounds once the base unit is found by the handset.
• Press the Programming key
• 'PIN' appears on the display.
• Enter the 4-digit PIN code of the base unit (default PIN code is '1590'). Use the number keypad.
• Press the Programming key
• The handset is subscribed to the base unit.
4.26 Subscribing a Butler 1800T handset to a Butler 24xx base unit
The below procedure only applies to a Butler 1800T handset and Butler 1210 base unit!!
Press the Paging key
op the base unit starts to blink quickly. The Line/Charge indicator
minute. During this minute, the base unit is in subscribing mode and you must do the
following to subscribe the handset:
• Press the
key once.
• Press the OK key and select a base unit (1-4) with the
• Press the OK key.
• Enter the PIN code of your base unit. Usually: 0000.
• Press OK. The Butler 1800T now searches for your DECT base unit. As soon as it finds it, you
will see the identification code of this base unit on the display.
• Press OK to confirm your selection or press ESC to cancel the subscription.
4.27 Removing subscription of a handset to a base unit
It is possible to cancel subscription of a handset to a base unit. You would do this if a
handset is damaged and has to be replaced by a new one.
Caution: You can only cancel subscription of another handset, not the handset you are using to do the
cancellation procedure.
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• Press the Up or Down key
• Press the Programming key
• 'PIN' appears on the display.
• Enter your 4-digit PIN code in (default PIN code is '0000'). Use the number keypad.
• Press the Programming key
• 'REMOVE HS' appears on the display.
• Dial the number of the handset you want to remove (1 –5). Use the number keypad.
• Press the Programming key
• 'REMOVE HS' appears on the display and the handset is removed
• NOT SUB' appears on the handset removed.
appear on the display.
.
.
on the base unit for 10 seconds until the Line/Charge indicator
.
repeatedly until 'SETTING' appears on the display.
.
repeatedly until 'REMOVE HS' appears on the display.
.
.
.
21
21
21
21
21
21
21
21
21
21
will blink quickly for one
keys.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Butler 2410

Table des Matières