dji T Serie Guide D'utilisateur page 9

A-B Route Operation Mode
After the aircraft enters A-B Route Operation Mode, the spinner disk spins. When the aircraft reaches the first turning
point, the hopper gate opens according to the set value and the aircraft flies along the route and spreads material
automatically. Spreading cannot be started or stopped manually.
The operation resumption function can be used during operation. Once the operation is paused, the hopper gate
closes automatically to stop spreading while the spinner disk is still spinning. After operation is resumed, the aircraft
returns to the breakpoint or projection point and continues spreading.
Manual Plus Operation Mode
Switch to M+ after the aircraft takes off. Press the Spray button on the remote controller to start the spinner
disk. The hopper gate opens according to the set value and the aircraft spreads material automatically once it
has begun flying.
Manual Operation Mode
Switch to M after the aircraft takes off. Use the Spray button on the remote controller to start or stop spreading.
In all operation modes except Manual Operation Mode:
When the aircraft flies forward or backward, the hopper gate opens automatically to start spreading.
•
When the aircraft flies left or right, the hopper gate closes automatically to stop spreading while the
•
spinner disk continues to spin.
Spreading System Calibration
When to Calibrate
The Spreading System has been calibrated before delivery. There is no need to calibrate before using for the first
time. Calibration is required in any of the following cases:
• The hopper gate cannot fully open or close.
• The material delivery rate is different from the desired value.
• The app incorrectly displays empty tank warnings.
Calibration Procedure
In the app, enter Operation View. Tap
indicates calibration is complete. If calibration fails, try again.
Maintenance
1. Clean the residue inside the spread tank and spreader regularly. It is recommended to use dry compressed
air and a clean, soft dry cloth. DO NOT rinse with liquids.
2. The spinner disk is a consumable part. If obvious signs of wear are noticeable, follow the steps below to
replace the spinner disk.
a. Make sure that the aircraft is powered off, and then unplug the Spreading System cable.
b. Detach the spreader.
c. Remove the nut, washer, four M3×8 screws, and spinner disk at the bottom of the spreader. Mount a new
spinner disk and secure it using the washers, M3×8 screws, and nut.
© 2020 DJI All Rights Reserved.
8
, , then tap Calibration in Spreading System Settings. Wait until the app