dji T Serie Guide D'utilisateur page 8

10. Insert the spread tank to the bottom of the aircraft frame and make sure it is in position. Insert and tighten two
M4×12 screws to the rear of the tank.
Operate with caution to avoid injury caused by mechanical parts.
Usage
1. Rotate the cover to open, add compatible materials, and tighten the cover.
2. Power on the remote controller, and then power on the aircraft.
3. Enter Operation View in the app. The following descriptions use the DJI Agras app as an example.
4. Tap the hopper outlet size display on the left of the screen to set the hopper outlet size, spinner disk
rotating speed, flying speed, line spacing, height relative to the vegetation, and banked turning. Adjustable
parameters vary depending on the operation mode. Adjust the settings so that they are suitable for the
materials you are using and test to make sure the performance is as expected.
For the Spreading System 1.0, when measuring between 7.5 to 9 kg/ha of materials spread, it is
recommended to:
• Adjust the hopper outlet size so that the material delivery rate is 1 kg/min.
• Adjust the spinner disk rotating speed so that the spreading range is 4 to 6 meters.
• Set the flying speed to 4 m/s (flying speed setting is unavailable in Manual Operation Mode).
For the Spreading System 2.0, when measuring 45 kg/ha of materials spread, it is recommended to:
• Adjust the hopper outlet size so that the material delivery rate is 8 kg/min.
• Adjust the spinner disk rotating speed so that the spreading range is 5 to 7 meters.
• Set the flying speed to 5 m/s (flying speed setting is unavailable in Manual Operation Mode).
5. Enter the operation mode required for spreading. The operations of the Spreading System vary depending on the
operation mode.
Route Operation Mode
After starting an operation, the aircraft ascends to an altitude of 4 meters and the spinner disk spins. When the
aircraft reaches the route starting point, the hopper gate opens according to the set value and the aircraft flies along
the route and spreads material automatically. Spreading cannot be started or stopped manually.
The operation resumption function can be used during operation. Once the operation is paused, the hopper gate
closes automatically to stop spreading while the spinner disk is still spinning. After operation is resumed, the aircraft
returns to the breakpoint or projection point and continues spreading.
© 2020 DJI All Rights Reserved.
7