dji T Serie Guide D'utilisateur page 3

Table des Matières

Disclaimer

Carefully read this entire document and all safe and lawful practices provided by DJI

for the first time. Failure to read and follow instructions and warnings may result in serious injury to yourself

or others, damage to your DJI product, or damage to other objects in the vicinity. By using this product, you

hereby signify that you have read this disclaimer carefully and that you understand and agree to abide by the

terms and conditions herein. You agree that you are solely responsible for your own conduct while using this

product, and for any consequences thereof. DJI accepts no liability for damage, injury, or any legal responsibility

incurred directly or indirectly from the use of this product.

DJI is a trademark of SZ DJI TECHNOLOGY CO., LTD. and its affiliated companies. Names of products, brands,

etc., appearing in this document are trademarks or registered trademarks of their respective owner companies. This

reproduced in any form without the prior written consent of or authorization from DJI.

This disclaimer is available in various languages. In the event of divergence among different versions, the

English version shall prevail. The final interpretation of this document and all related documents of this product

belongs to DJI. This content is subject to change without prior notice. For up to date product information, visit

http://www.dji.com and click on the product page for this product.

Warnings

1. The T Series Spreading System (abbreviated as Spreading System) is only compatible with the DJI AGRAS

series aircraft, and the firmware of the aircraft must be the correct version for supporting the Spreading System.

Refer to the Specifications section for more information about compatible aircraft. DO NOT use it with other

products or for purposes other than agriculture.

2. The Spreading System is compatible with dry materials of a diameter between 0.5 - 5 mm. DO NOT use with

other materials. If used with other materials, the operating performance will be negatively affected and the

Spreading System may be damaged. All materials must be used in strict accordance with the instructions for

those materials.

3. The max internal spread tank load depends on the takeoff weight of the aircraft. DO NOT overload. Refer to the

Specifications section for more information.

4. When connecting the cables, make sure the connection is correct and secure. Operate with caution to avoid

damaging the cables.

5. Make sure that the hopper gate and spinner disk function normally before each use.

6. Operate with caution to avoid injury caused by mechanical parts.

7. When spreading is in progress, maintain a safe distance from the Spreading System to avoid injury.

8. When spreading is in progress, the minimum detection distance of the radar module will be 5 m instead of

1.5 m due to obstruction from the materials being spread. Note that the aircraft cannot sense obstacles that

are not within the detection range. The detection performance of the radar module will also decrease. Fly

with caution. Refer to the disclaimer and safety guidelines of the corresponding aircraft you are operating for

more information on the radar module.

9. DO NOT use liquids to rinse the Spreading System. It is recommended to use dry compressed air as a cleaning agent.

Introduction

The T Series Spreading System is compatible with Agras T series aircraft and offers efficient, reliable, and stable

spreading operations. The material delivery system is precisely controlled by the built-in stirring device and hopper

before using this product

Table des Matières