dji T Serie Guide D'utilisateur page 4

gate, which can prevent material blockages and improve operating accuracy and reliability.
Use the app compatible with your aircraft to set parameters such as the hopper outlet size and spinner disk rotating
speed. These parameters can be adjusted to meet different requirements. The app provides warning prompts for an
empty tank as well as for abnormalities in the rotating speed, temperature, and hopper outlet size. These prompts
help ensure system safety.
The Spreading System has two versions, 1.0 and 2.0. They each have a different structure for the spinner disk.
Compared with the Spreading System 1.0, the Spreading System 2.0 has a higher material delivery rate and can
spread materials 360° around the aircraft. Unless otherwise specified, the descriptions in this document use the
Spreading System 1.0 as an example.
In the Box
Spreading System × 1
Overview
Installation
Make sure to remove the Intelligent Flight Battery from the aircraft before installation. Hex keys for M2.5, M3
and M4 screws are required for installation.
1. Lift and remove the spray tank on the aircraft.
2. Removeall of the rubber stoppers and five M3×8 screws on the upper cover on the front of the aircraft,
and then remove the upper cover. For the T20 aircraft, the cable strainer protector on the left must also be
removed.
Spare Spinner Disk × 2
Spreader Lock
Cable
M4×12 Screws × 4
Spread Tank
Spreader
Spinner Disk
Users have the option to
purchase a fender with a
screw pack to use with the
Spreading System 2.0.
© 2020 DJI All Rights Reserved.
3