Table des Matières
Publicité
8. Insert the spread tank in the aircraft. DO NOT insert it to the bottom of the aircraft frame. Make sure that the
middle of the tank is approximately 5 cm from the middle frame of the aircraft, as shown in the figure below.
9. Mounting the spreader:
a. Face the rear of the aircraft and check the spreader lock knob is in an unlocked position. Insert the spreader
with the knob located to the left of the circular indentation on the spread tank.
b. Rotate the spreader to mount it to the spread tank. To lock the spreader, pull the spreader lock knob out, rotate
it 90°, and release. Make sure that the spreader is locked in position.
c. Secure the Spreading System cable to the landing gear using the Velcro on the cable.
© 2020 DJI All Rights Reserved.
6
5 cm
3
2
1
Publicité
Table des Matières
