Practical Tips; Switching The Light On And Off; Removing Obstructions And Blockages - Grizzly ESF 2046 L Traduction De La Notice D'utilisation Originale

The operating display (25) will
flash green.
3. To switch on press
the release button
(24) while holding
down the start han-
dle (2). Disengage the release
button.
The auger will start to turn.
4. To switch off re-
lease the start han-
dle (2).
Overload protection: The motor
will switch off automatically, if the
machine is overloaded. Release the
start handle and start the machine
again after it has cooled down.

Practical tips

After work and to transport: Switch
the machine off, disconnect the
power lead and ensure that all mov-
able parts have stopped moving.
There is a risk of personal injury.
Observe the noise protection and
local regulations.
• Work with care, especially if you
change the movement direction.
• Always keep the extension cable be-
hind you and place it on the area which
is ready when you turn.
• Move the machine slowly (at walking
speed) and in lines which should be
as straight as possible so that the lines
overlap a bit.
• We recommend that the machine
may be used for snow heights of up to
20 cm.
• Clear snow when it is loose, freshly
fallen, as the layer of snow can turn
STOP START
I
3 2
STOP
3
to ice later, making the work more dif-
ficult.
• Do not use the machine with snow that
is very hard and frozen. The rubber
1
covering of the auger could be dam-
aged.
• Clear the snow in the wind direction as
far as possible.
• Switch the machine off and tilt it, if you
have to cross a gravel path or sensitive
START
surfaces.
1
I
• The carry handle (
2
machine easier to transport.
• Allow the motor to run for a short
period of time after you have com-
pleted the work so that any moisture
is removed and no moving parts can
freeze.
• Clean the machine after each use, as
described in the section "Cleaning/
Maintenance".

Switching the light on and off

The light only works while the machine is
in operation.
1. To switch on the light (4), place
the on/off switch (3) in position
"I".
2. To switch off the light (4), place
the on/off switch (3) in position
"0".
Removing obstructions and
blockages
Attention! Shut off motor before
unclogging discharge chute.
Snow can block the auger or the ejector
chute.
GB
17) makes the
49