Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
If the roof of the vehicle is sloped (not level) such
that the roof top heat pump cannot be mounted
within the maximum allowable degree deviations, an
exterior leveling shim will need to be added to make
the roof top heat pump level. A typical leveling
shim is shown in Figure 4.
E.
After the mounting hole area is properly prepared,
remove the carton and shipping pads from the roof
top heat pump. Carefully lift the unit on top of
the vehicle. Do not use the outer plastic shroud
for lifting. Place the roof top heat pump over
the prepared mounting hole. The pointed end
(nose) of the shroud must face towards the front of
the vehicle. Pull the electrical conduit down from
the roof heat pump through the mounting opening
and let hang.
5
Publicité
Chapitres
