Getting Started - Ribimex RIBITECH PRM115/501 Manuel D'instructions Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.13- Handling, transport and storage of the disks.
The disks are fragile and sensitive to shocks and impacts. Therefore, special precautions should be taken:
a) Do not let the disk fall and avoid impacts.
b) Do not use a disk that has fallen or that is damaged.
c) Avoid strong vibrations or vibrations during operation.
d) Prevent damage to the bore
e) Avoid excessive loads on the cutting surface.
f) Store disks perpendicular or flat, in a dry location, protected from frost and at a constant positive
temperature.
g) Keep disks in their original packaging or in special packaging and on shelves.
IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected from
its power source.
4.1- Unpacking
- Remove product from its packaging.
- Check that tool and accessories are not damage
The set includes:
1 angle grinder
1 auxiliary handle
1 pin spanner
1 protective guard for grinding operations
4.2- Auxiliary handle assembly (Fig.2)
For user's own safety, it is essential to use the side handle, which must be assembled as follows:
- Make sure that tool is unplugged.
- The side handle can be fitted to either side of the machine to suit the operator.
- Insert handle in your preferred position and then firmly screw it.
4.3- Protective guard
4.3.1- Présentation (Fig.3)
The angle grinder is delivered with a protective guard for sanding/grinding operations only.
The protective guard for grinding operations is NOT intended for cutting off operations, as these operations
require a specific protective guard.
4.3.2- Protective guard assembly (Fig.4)
- Make sure that tool is unplugged.
- Remove the flange and flange nut.
- Slightly unscrew the screw on protective guard clamping collar.
- Align the lug on clamping collar with the notch on angle grinder collar (Fig.4a).
- Press guard down and rotate it (Fig.4b) to required working position (Fig.4c).
Note: Adjust the protective guard so as to prevent the projection of sparks or dust towards the user.
- Tighten screw on protective guard clamping collar.
- Make sure that the protective guard is correctly assembled and that screw is tightly fitted.
- The protective guard must always be fitted during operation.
Page 20 / 21

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

510306

Table des Matières