Techness RUN1000 Mode D'emploi page 49

All manuals and user guides at all-guides.com
TREADMILL MAINTENANCE
Proper maintenance is very important to ensure a faultless and operational condition of
the treadmill. Improper maintenance can cause damage to the treadmill or shorten the life
of the product.
All parts of the treadmill must be checked and tightened regularly. Worn out parts must be
replaced immediately.
1. LUBRICATION
The treadmill is factory-lubricated. However, it is recommended to check the lubrication of
the treadmill regularly, to ensure an optimal operation of the treadmill. It is usually not
necessary to lubricate the treadmill in the first year or the first 500 hours of operation.
After every 3 months of operation, lift the sides of the treadmill and feel the surface of the
belt, as far as possible. If traces of silicon spray are found, lubrication is not necessary.
In case of a dry surface refer to the following instructions.
Only use oil free silicon spray.
2. Application of lubricant on the belt:
● Position the belt so that the seam is located in the middle of the plate.
● Insert the spray valve in the spray head of the lubricant container.
● Lift the belt at one side and hold the spray valve in a distance to the front end of striding
belt and plate. Start at the front end of the belt. Lead the spray valve in direction of the
back end. Repeat this process on the other side of the belt. Spray each side for about 4
seconds.
● Wait 1 minute to let the silicon spray spread, before starting the machine.
3. CLEANING:
Regular cleaning of the striding belt ensures a long product life.
● Warning: The treadmill must be turned off to avoid electrical shocks. The power cord
must be pulled out of the socket, before starting the cleaning or maintenance.
●After each training: Wipe the console and other surfaces with a clean soft and damp
cloth to remove sweat residues.
Caution: Do not use any abrasives or solvents. To avoid damage to the computer, keep
any liquids away. Do not expose the computer to direct sunlight.
●Weekly: To make the cleaning easier it is recommended to use a mat for the treadmill.
Shoes can leave dirt on the striding belt that can fall beneath the treadmill. Clean the mat
under the treadmill once a week.
4. BELT ADJUSTMENT
You may need to adjust the running belt during the first few weeks of use. All running
belts are properly set at the factory. It may stretch of be off center after use. Stretching is
normal during the break-in period.
ADJUSTING THE BELT TENSION:
If the running belt feels as though it is ―slippingǁ or hesitating when you plant you foot
during a run, the tension on the running belt may have to be increased.
49