Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
No speed sensor signal ：
E03
control board has send the
signal to motor, but can not
receive the signal from motor
for 3seconds.
Incline motor learn by itself
E04
Over
E05
treadmill is running, control
board check the current is
over standard current +6A for
3 seconds
E06
Over explosion protection:
voltage is not correct or
motor not work well, cause
motor wire bad.
All manuals and user guides at all-guides.com
current
protection:
Treadmill can not start, warning sound
9times. Console show the E03. If treadmill
can restart in 10 seconds, it will be ok.
Solution: No speed sensor signal for
3seconds, then check the sensor plug or
change the speed sensor.
Check the incline motor wire, and wire
connections. Check the AC wire on incline
motor and the connection to control board.
Change the wire or incline motor. Then
press the key to let the incline motor learn
by itself.
Treadmill can not start, warning sound
9times. Console show the E05. If treadmill
can restart in 10 seconds, it will be ok.
Solution: current is over the standard
current, so system take protection. Or some
part can not work; causing the motor can not
run normally. Recheck the treadmill, and
restart the treadmill. Check if the bad smell,
change motor, or control board has.
Recheck the current is right or not.
Treadmill can not start, warning sound
9times. Console show the E06. If treadmill
can restart, it will be ok.
Solution: check the voltage is lower than
10% standard voltage, using the correct
voltage to check again. Check control board
smelling, if burnt smell, change control
board. Check the motor wire connection,
reconnect.
48
Publicité
Table des Matières
