Cleaning And Maintenance - Russell Hobbs RHIC202 Manuel D'instructions

Thermal
Sensor Open
E5 Circuit and
Short Circuit
Protection
Plate
E6 Overheating
Protection

CLEANING AND MAINTENANCE


Discolouration, burn marks or stains may result from the use of pots and pans that
have not been cleaned properly.

Clean the induction cooker after each use to avoid stains caused by a build-up of
food or grease residues. Never leave food on the black crystal surface overnight.

Always unplug the unit and allow it to cool before starting to clean.

Clean the induction cooker while still warm after use. Wipe the black crystal surface
with warm soapy water using a sponge or dishcloth only. Normal dish washing liquid
should be sufficient. For excess soiling, after the unit is cool, wash the black crystal
surface with a soft sponge moistened with a non-abrasive kitchen cleaner.

Never scrape with hard or sharp utensils when cleaning.

Use a non-abrasive sponge or damp dish cloth to clean the exterior of the induction
cooker.

Wipe the unit thoroughly to remove soap residue. Ensure that all parts are
thoroughly dried.

Use a vacuum cleaner to carefully suck up dirt from the air intake and exhaust vent.

Do not use petrol, acetone, vinegar, alcohol, benzene, bleach, solvents, abrasive
cleaners or scouring pads to clean your appliance as it can be damaging to the finish.

Never immerse the cord or plug in any liquid.

Do not soak the induction cooker in water.

Do not place heavy objects on the black crystal surface as this surface is breakable.

This appliance is for household use only and is not user-serviceable.

Do not open or change any parts by yourself. Please refer to a qualified electrical
service department or return to the supplier if servicing is necessary.
the induction cooker will stop
heating and a beep will sound
every second.
Should the IGBT, thermal sensor
or black crystal plate become
open circuit or short circuit then
the induction cooker will stop
heating. The unit will check this
state every minute.
Should the temperature of the
black crystal plate or cookware
become too high then the
induction cooker will stop
producing heat.
19
function as normal.
A beep will sound and will
not stop until you touch the
"ON / OFF" key. Visit your
nearest authorized service
centre.
A beep will sound every
second and will not stop until
you touch the "ON / OFF"
key. Unplug the unit and let
it cool down for
approximately 10 minutes.
Then switch the appliance
back on and use as normal.