Kenmore W10789009A Instructions D'installation page 17

NOTE: Do not push on the front of the panel or on the console.
Panel or console may dent.
Helpful Tip: Temporarily tape utilities to the floor in the locations
shown to prohibit them from moving when dishwasher is moved
into the cabinet opening.
Check that water line is on the left side of opening and drain
hose is near the center of the cabinet opening.
With another person holding the dishwasher to keep it from
tipping, open and close the door a few times. If the door closes
or falls open under its own weight, the door tension will need to
be adjusted.
If the door closes too quickly, decrease the spring tension by
moving the spring end toward the front of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
If the door falls open, increase the spring tension by moving the
spring end toward the back of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
IMPORTANT: If rear leveling legs and spacers were removed,
cover the floor when moving the dishwasher to avoid damage
to the floor. Slowly move dishwasher completely into cabinet
opening. Do not kink or pinch water line, drain hose, power
supply cord or direct wire between dishwasher and cabinet.
Remove cardboard from under dishwasher.
NOTES:
It is all right if dishwasher fits tightly into cabinet opening.
Do not remove insulation blanket – the blanket reduces the
sound level.
If using power cord, make sure to route end through hole in
cutout before sliding dishwasher into cabinet opening.
17