Make Power Supply Cord Connection - Kenmore W10789009A Instructions D'installation

Using two or more people, grasp sides of dishwasher door
frame and place dishwasher on its back.
Using a flat-blade screwdriver, turn the plastic fasteners ¹⁄₄ turn
counterclockwise to unlock them. Remove the panel. Do not
remove tech sheet from access panel.
Using a ¹⁄₄" hex head socket, nut driver or Torx
remove terminal box cover. Retain for later use.
12
Install a UL Listed/CSA Approved strain relief. Make sure
screwheads are facing to the left when tightening conduit nut.
Strain relief is provided with the power supply cord kit.
NOTE: If using Option B, proceed to "Determine Cabinet
Opening," to continue with the installation of your dishwasher.
Option A, Power Supply Cord:
T20 screwdriver,
®
Route cord so that it does not touch dishwasher motor or lower
part of dishwasher tub. Pull cord through strain relief in terminal
box.

Make Power Supply Cord Connection