Product Operation - Marshalltown Bullet EZ Serie Mode D'emploi

Caution! Wear hand and eye protection while operating the EZ Siding Shear
1 – While gently pushing handle down, pull Safety Lock
pin out, then lift handle.
3 – Push handle down until the material is cut
completely. Some effort may be required depending
of hardness of material.
WS2647revA
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

PRODUCT OPERATION

2 – Place product on table. Bring handle down
until blade touches material.
Double Cutting – Simply make your first cut
1/8" to 1/4" (3mm to 6mm) longer than your
mark and then make a second cut on your
mark. This is very useful to create a cleaner
cut on exposed ends or when you cannot over
the cut edge with molding or trim.
7 of 16