Product Operation - Marshalltown FS213-L Mode D'emploi

1. Press down handle and carefully remove the
Cam Locking Pin. Insert Cam Locking Pin into its
storage hole to prevent losing the pin. Carefully
raise and release the handle.
1. Loosen wing nuts and remove the Bed Fence. Insert the fence into either of the angled holes for the desired
cut and tighten wing nuts.
Some materials may require the double cutting method to obtain a clean cut. For these materials, make your
first cut 1/4" longer than your mark. Then, make a second cut on your mark. This method will help produce
cleaner cuts on some materials.
WS2179
104 S. 8th Ave. Marshalltown, IA Phone 800-888-0127 / 641-753-0127 • Fax 800-477-6341 / 641-753-6341 www.MARSHALLTOWN.com

PRODUCT OPERATION

2. Place material to be cut on the table and slide past
the blade to the desired length. Press flooring
against the Bed Fence and hold firmly in place to
ensure a clean and accurate cut. Press handle
down until the blade touches the material and then
firmly press down on the handle until the material
is cut.
45 DEGREE CUTS
DOUBLE CUTTING
7 of 48