Easy Steps To Operate Your Angelcare; Parent Unit (Receiver) - Anglecare AC420 Manuel De L'utilisateur

4 EASY STEPS TO OPERATE YOUR ANGELCARE

STEP 1
Adapter socket
Microphone
sensitivity
dial
NURSERY UNIT (TRANSMITTER)
• Insert 4 AAA regular batteries (not included) into Nursery
Unit (for battery backup in case of power failure).
• Connect AC adapter to Nursery Unit and plug adapter into an
electrical outlet in the baby's room.
• After both units are properly installed (step1 and 2), turn
them ON and then adjust microphone sensitivity level (if
necessary).
STEP 3
Power ON/OFF
Channel
selector
HOW TO USE YOUR MONITOR
• To be warned if your units are "out of range", switch the In
Range Notification ON (optional).
• If reception is not clear, switch to another channel. (see
instructions for changing channel in the "ICON" section).
• To avoid feedback (whistling sound), keep both units at
least 3 meters apart (10 feet).
In range ON/ OFF
Channel selector
ON/ OFF night light
button
Power ON/OFF
STEP 2
Volume controls
(up & down)

PARENT UNIT (RECEIVER)

• Insert 4 AAA NIMH rechargeable batteries (included) into
Parent Unit.
• Connect AC adapter to Parent Unit charger and plug adapter
into an electrical outlet. Let charge for 15 continuous hours
before using the monitor for the first time.
• After both units are properly installed (step1 and 2), turn
them ON and then adjust the volume control to the desired
level.
STEP 4
Low battery indicator
USING THE BATTERY MODE
• The monitor will revert to battery mode during a power
failure only if batteries are inserted in both units.
• When the Nursery Unit's green light flashes, its batteries
need to be replaced. On the Parent Unit screen, the clear
battery icon flashes and the Nursery Unit icon appears. A
beep sound is also heard.
• Parent Unit should be recharged when icon is clear (does not
flash) and a beep sound is heard. Note: Do not use Alkaline
batteries in the Parent Unit.
9
® MONITOR
Charger adapter
socket
E
N